The air conditioning control assembly communicates with the air conditioning amplifier assembly via LIN communication.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with air conditioning control assembly | ·
Harness or connector between air conditioning control assembly and power source ·
Harness or connector between air conditioning control assembly and body ground ·
LIN communication system ·
Air conditioning control assembly ·
Air conditioning amplifier assembly |
Memorized
(10 seconds or more)* |
*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the F61 air conditioning control assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F61-10 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| F61-10 (IG+) - Body ground | Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F61-16 (GND) -Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F72 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F61-2 (LIN1) - F72-3 (LIN1) | Always | Below 1 Ω |
| F61-2 (LIN1) or F72-3 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the F72 air conditioning amplifier assembly connector.
Turn the ignition switch ON.
Connect an oscilloscope to terminals F72-3 (LIN1) and F72-29 (GND) of the air conditioning amplifier assembly and check the waveform.
Waveform is similar to that shown in the illustration.
| Item | Content |
|---|---|
| Tool Setting | 2 V/DIV., 20 ms./DIV. |
| Vehicle Condition | Ignition switch ON |
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
- | - |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the F61 air conditioning control assembly connector.
Turn the ignition switch ON.
Connect an oscilloscope to terminals F61-2 (LIN1) and F61-16 (GND) of the air conditioning control assembly and check the waveform.
Waveform is similar to that shown in the illustration.
| Item | Content |
|---|---|
| Tool Setting | 2 V/DIV., 20 ms./DIV. |
| Vehicle Condition | Ignition switch ON |
| *a | Component with harness connected
(Air Conditioning Control Assembly) |
- | - |
| Proceed to |
|---|
| OK |
| NG |
OK
NG