The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 cooler thermistor removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
87130D
1.REMOVE BLOWER ASSEMBLY
82210K
2.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
87050C
3.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87128
4.REMOVE HEATER PIPE GROMMET
87124B
5.REMOVE HEATER CLAMP
87107A
6.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88515
7.REMOVE COOLER EXPANSION VALVE
88501
8.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625
9.REMOVE NO. 1 COOLER THERMISTOR
Remove the No. 1 cooler thermistor.