The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the solar sensor removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55950G
2.REMOVE DEFROSTER NOZZLE ASSEMBLY
89120A
3.REMOVE AUTOMATIC LIGHT CONTROL SENSOR
Disconnect the connector.
Disengage the claws to remove the automatic light control sensor.