Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY › from 2020.08
RM32H0E _57 Power Source / Network _060596 POWER DISTRIBUTION _0297232 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the No. 1 integration relay removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E353734C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the claws to remove the No. 1 relay block cover as shown in the illustration.


Hide 82641 4.REMOVE NO. 1 INTEGRATION RELAY

a.
E353736C01
1.333,1.833 1.75,1.625 true 1.135,1.729 1.302,1.896 0.167,0.167 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws.


b.

Pull up the No. 1 integration relay as shown in the illustration.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.



c.
E353738

Disconnect the 2 connectors to remove the No. 1 integration relay.

NOTICE:

When pulling the No. 1 integration relay, take care not to damage it.