The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
45130
1.REMOVE HORN BUTTON ASSEMBLY
84250A
2.REMOVE STEERING PAD SWITCH ASSEMBLY
Disconnect connector from the spiral cable with sensor sub-assembly.
Remove the 2 screws.
Disengage the 4 claws and 4 pins to remove the steering pad switch assembly.