Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL PRESSURE SENSOR › from 2020.08
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293897 FUEL PRESSURE SENSOR A

8NR-FTS FUEL  FUEL PRESSURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel delivery pipe (fuel pressure sensor) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 23814B 1.REMOVE FUEL DELIVERY PIPE (FUEL PRESSURE SENSOR)

Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL INJECTOR>REMOVAL

NOTICE:
·

Do not remove the fuel pressure sensor from the fuel delivery pipe.

·

If the fuel pressure sensor is removed, replace the fuel delivery pipe (fuel pressure sensor) with a new one.



Hide 2.REMOVE FUEL PIPE PLUG SUB-ASSEMBLY

a.
A380592

Secure the fuel delivery pipe in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a 5 mm hexagon socket wrench, remove the 2 bolts, gasket and fuel pipe plug sub-assembly from the fuel delivery pipe.


c.

Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.


d.

Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe plug sub-assembly.


e.

Remove the fuel delivery pipe from the vise.