Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ECU › from 2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296125 HEADLIGHT ECU A

LIGHTING (EXT)  HEADLIGHT ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight ECU sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



NOTICE:

If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


PROCEDURE

Hide 89907 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E420095

Remove the 3 screws.


b.
E420096

Disconnect the connector cover from the headlight ECU sub-assembly.


c.

for TMMT Made:

i.
E420097

Disconnect the 2 connectors to remove the headlight ECU sub-assembly.

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.




d.

for TMC Made:

i.
E426160

Disconnect the connector to remove the headlight ECU sub-assembly.

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.




Hide 81134 3.REMOVE HEADLIGHT GASKET

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E420098

Remove the headlight gasket.