Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Single Beam Headlight) › from 2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0406609 HEADLIGHT ASSEMBLY(for Single Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Single Beam Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



NOTICE:

If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 85319A 4.SEPARATE INLET HOSE (for RH Side)

E436576

a.

Remove the clip to separate the inlet hose.


Hide 5.REMOVE HEADLIGHT ASSEMBLY

a.
E420060C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the headlight assembly as shown in the illustration.


b.
E420071C02
0.552,2.99 0.625,2.719 true 0.375,2.969 0.583,3.167 0.208,0.198 10 true *a 3.063,1.927 3.25,2.115 0.188,0.188 12 true A 3.083,2.865 3.271,3.052 0.188,0.188 12 true B
*a Connector Lock Lever
V113147

Remove in this Direction


Disconnect the connector A.


c.

Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector B.


d.
E420062

Remove the bolt and 3 screws.


e.
E420063C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the headlight assembly as shown in the illustration.