The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the windshield wiper relay assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
85940
2.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY
Disconnect the connector.
Remove the bolt.
Disengage the guide to remove the windshield wiper relay assembly.