Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0291560 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Lane tracing assist system

·

Front radar sensor system

·

Pre-collision system


Triangle Target:(Click here)
Flat Surface Target:(Click here)
Driving Adjustment:(Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 88215 2.REMOVE NO. 1 MILLIMETER WAVE RADAR SENSOR BRACKET

a.
C365304

Remove the 2 bolts.


b.

Disengage the guide to remove the No. 1 millimeter wave radar sensor bracket.


Hide 88211B 3.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
B586031C03
0,0 0,0 false
V100135

Bolt
V100136

Screw


Remove the 2 bolts and screw.


b.

Disengage the guides to remove the millimeter wave radar sensor assembly.

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.