Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297889 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P163181  Communication Error from ECM to VSC Invalid Serial Data Received  


DESCRIPTION

The skid control ECU (brake actuator assembly) sends signals such as brake request signals to the ECM. When the ECM detects logic error signals sent from the skid control ECU (brake actuator assembly) for a certain period of time, DTC P163181 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
P163181 Communication Error from ECM to VSC Invalid Serial Data Received When the ignition switch is ON and the dynamic radar cruise control system is operating, the ECM detects logic error signals sent from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

Vehicle stability control system

·

ECM


Cruise Control

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs
a.

Check for vehicle stability control system DTCs.

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

2.CLEAR DTC

B

2.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 374

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs
3.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC P163181 is not output A
DTC P163181 is output B



A

B