Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0292294 ROAD SIGN ASSIST SYSTEM D

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  VEHICLE CONTROL HISTORY  


NOTICE:

When checking the Vehicle Control History, make sure to record the output codes. Then, clear the Vehicle Control History (RoB) and check it again.


CHECK VEHICLE CONTROL HISTORY (ROAD SIGN ASSIST SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Utility / Vehicle Control History (RoB)

Body Electrical > Road Sign Assist > Utility
Tester Display
Vehicle Control History (RoB)
50005 431 55

e.

According to the display on the GTS, read the Vehicle Control History (RoB).

Vehicle Control History (RoB)
Multi-information Display Code Tester Display Description Diagnostic Note
RSA Malfunction Visit Your Dealer X2000 Yaw Rate Sensor Malfunction The forward recognition camera received a yaw rate sensor (airbag sensor assembly) malfunction signal from the yaw rate sensor (airbag sensor assembly). Perform troubleshooting for the vehicle stability control system.
(Click here)
RSA Malfunction Visit Your Dealer X2004 Speed Sensor Malfunction The forward recognition camera received a vehicle speed sensor malfunction signal from the skid control ECU (brake actuator assembly). Perform troubleshooting for the vehicle stability control system.
(Click here)
- X2011 Front Recognition Camera System Software Not Programmed The forward recognition camera cannot store the vehicle information. Perform troubleshooting for the front camera system.
(Click here)
RSA Malfunction Visit Your Dealer X2012 Front Recognition Camera Malfunction The forward recognition camera detected an internal malfunction. Perform troubleshooting for the front camera system.
(Click here)
RSA Malfunction Visit Your Dealer X2013 Front Recognition Camera Optical Axis Misalignment Malfunction The forward recognition camera detected optical axis misalignment. Refer to DTC C1AA800 in Front Camera System
(Click here)
RSA Malfunction Visit Your Dealer X2014 Front Recognition Camera Optical Axis Not Adjusted Forward recognition camera optical axis adjustment has not been performed. If this Vehicle Control History code is output, perform forward recognition camera optical axis adjustment, clear the Vehicle Control History and then check that this code is not stored again.
HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click here(Click here)

Sequential Recognition: Click here(Click here)

Driving Adjustment: Click here(Click here)


- X2015 Front Recognition Camera Dirt System operation was temporarily suspended due to the forward recognition camera not being able to detect objects. Refer to Vehicle Control History code X2015 of Front Camera System.
(Click here)
- X2016 Front Recognition Camera Outside Guaranteed Operating Temperature System operation was temporarily suspended due to the forward recognition camera being excessively hot or cold. Refer to Vehicle Control History code X2016 of Front Camera System.
(Click here)
- X2017 Front Recognition Camera Outside Guaranteed Operating Voltage System operation was temporarily suspended due to forward recognition camera power source voltage being excessively high or low. Refer to Vehicle Control History code X2017 of Front Camera System.
(Click here)
RSA Malfunction Visit Your Dealer X201D Front Recognition Camera System Software Malfunction The forward recognition camera detected specification information malfunction. Perform troubleshooting for the front camera system.
(Click here)
- X2077 Ambient Temperature Sensor Circuit The forward recognition camera received an ambient temperature sensor malfunction signal from the air conditioning amplifier assembly. Perform troubleshooting for the air conditioning system.
for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor:(Click here)
for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor:(Click here)
for Manual Air Conditioning System:(Click here)
RSA Malfunction Visit Your Dealer X2084 Meter Speed Tolerance Malfunction The forward recognition camera received a vehicle speed tolerance malfunction signal from the combination meter assembly. Perform troubleshooting for the meter / gauge system.
(Click here)



CLEAR VEHICLE CONTROL HISTORY (ROAD SIGN ASSIST SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Utility / Vehicle Control History (RoB)

Body Electrical > Road Sign Assist > Utility
Tester Display
Vehicle Control History (RoB)
50005 431 55

e.

Clear the Vehicle Control History (RoB) according to the display on the GTS.

NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.