The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
51441
1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
27020
3.REMOVE GENERATOR ASSEMBLY
for DENSO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for DENSO Made)>REMOVAL
for VALEO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for VALEO Made)>REMOVAL
16620
4.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
5.REMOVE ENGINE WATER PUMP ASSEMBLY
Remove the 6 bolts and engine water pump assembly from the timing chain cover assembly.
Remove the water pump gasket from the engine water pump assembly.