The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE FAN AND GENERATOR V BELT
4.REMOVE INTERCOOLER ASSEMBLY
27020
5.REMOVE GENERATOR ASSEMBLY
Remove the terminal cap.
Remove the nut to disconnect the engine wire from the terminal B.
Disconnect the generator assembly connector.
Remove the bolt and 2 nuts from the generator assembly.
Remove the generator assembly.