Home › Engine / Hybrid System › 8NR-FTS (COOLING) › THERMOSTAT › from 2020.08
RM32H0E _51 Engine / Hybrid System _060195 8NR-FTS COOLING _0295083 THERMOSTAT A

8NR-FTS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 16572D 4.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16267 5.DISCONNECT NO. 3 WATER BY-PASS HOSE (for CVT)

a.
A350054

Slide the clip and disconnect the No. 3 water by-pass hose from the water inlet with thermostat sub-assembly.


Hide 16267C 6.DISCONNECT NO. 4 WATER BY-PASS HOSE (for Manual Transaxle)

a.
A350054

Slide the clip and disconnect the No. 4 water by-pass hose from the water inlet with thermostat sub-assembly.


Hide 16031 7.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A350055

Remove the 2 bolts and water inlet with thermostat sub-assembly.


Hide 16326 8.REMOVE NO. 2 WATER INLET HOUSING GASKET

A350056

a.

Remove the No. 2 water inlet housing gasket from the water inlet with thermostat sub-assembly.