Home › General › MAINTENANCE › 8NR-FTS BATTERY › from 2020.08
RM32H0E _V1 General _059503 MAINTENANCE _0295270 8NR-FTS BATTERY A

MAINTENANCE  8NR-FTS BATTERY  INSTALLATION  


PROCEDURE

Hide 28800 1.INSTALL BATTERY

HINT:

Perform "clear the integrated current value", "switch battery type" after replacing the battery.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE


a.

Install the battery to the vehicle.


b.
A394404

Install the No. 2 battery clamp with the bolt.

Torque:
15.4 N*m (157 kgf*cm, 11 ft.*lbf)


c.

Install the battery insulator to the battery.


d.

Connect the cable to the positive (+) battery terminal and engage the clamp.


e.

Tighten the nut.

Torque:
5.6 N*m (57 kgf*cm, 50 in.*lbf)


f.
A387997

Engage the 2 claws and install the fusible link cover.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

a.

Connect the cable to the negative (-) battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic leaning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART