The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
84340
2.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
47101A
4.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.
47264A
5.REMOVE PUSH ROD PIN
Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.
47110
6.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
w/ Brake pedal Load Sensing Switch:
Disconnect the brake pedal load sensing switch connector.
Disengage the clamp to separate the wire harness from the brake pedal support assembly.
Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.
Remove the 2 clips.
Remove the 4 nuts and brake pedal support assembly.
Remove the nut from the brake pedal support assembly.
47121
7.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad from the brake pedal support assembly.