Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD) › from 2020.08
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298587 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 55401E 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 84345 2.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 3.REMOVE BRAKE PEDAL RETURN SPRING

a.
C366052

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 47264A 4.REMOVE PUSH ROD PIN

a.
C366053

Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.


Hide 47110 5.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.

w/ Brake pedal Load Sensing Switch:

i.
C366055

Disconnect the brake pedal load sensing switch connector.



b.
C366054

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C366056

Remove the 2 clips.


d.

Remove the 4 nuts and brake pedal support assembly.


e.
C366057

Remove the nut from the brake pedal support assembly.


Hide 47121 6.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.