Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU › from 2020.08
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0292796 4WD CONTROL ECU A

GF1A TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the 4WD ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When the 4WD ECU assembly is replaced with a new one, calibration is unnecessary.

Disconnect cable from negative battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)
4WD ECU assembly (When replaced with a normal one from another vehicle)*1 Clear zero point calibration data Dynamic torque control AWD system (Click here)

CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 62551F 3.REMOVE REAR SEAT SIDE GARNISH

Hide 89630A 4.REMOVE 4WD ECU ASSEMBLY

C360112

a.

Disconnect the connector.


b.

Remove the bolt and 4WD ECU assembly.