The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front door belt moulding removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
87940
3.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
67832
4.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
5.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
75720
6.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the front door belt moulding assembly.
|
Remove in this Direction |
Disengage the 6 claws as shown in the illustration to remove the front door belt moulding assembly.