The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the black out tape removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
69284C
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
74232
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
74231
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67492A
7.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
67862
8.DISCONNECT FRONT DOOR WEATHERSTRIP
68195
9.REMOVE FRONT DOOR BELT SEAL
68172A
10.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67838A
11.REMOVE FRONT DOOR VENT SEAL
87940
12.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
67832
13.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
14.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
67664
15.REMOVE DOOR FRAME UPPER GARNISH
68151C
16.REMOVE FRONT DOOR GLASS RUN
67402F
17.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY
68126
18.REMOVE FRONT DOOR FIX WINDOW GLASS
75966B
19.REMOVE NO. 4 FRONT DOOR STRIPE
When removing the No. 4 front door stripe, heat the vehicle body and No. 4 front door stripe using a heat light.
| Item | Temperature |
|---|---|
| No. 4 Front Door Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the No. 4 front door stripe and vehicle body.
Pull back on one of the ends of the No. 4 front door stripe to remove it.
When pulling on the No. 4 front door stripe, pull it parallel to the vehicle body.
75986G
20.REMOVE FRONT DOOR OUTSIDE STRIPE
When removing the front door outside stripe, heat the vehicle body and front door outside stripe using a heat light.
| Item | Temperature |
|---|---|
| Front Door Outside Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the front door outside stripe and vehicle body.
Pull back on one of the ends of the front door outside stripe to remove it.
When pulling on the front door outside stripe, pull it parallel to the vehicle body.
75976G
21.REMOVE NO. 2 FRONT DOOR STRIPE
When removing the No. 2 front door stripe, heat the vehicle body and No. 2 front door stripe using a heat light.
| Item | Temperature |
|---|---|
| No. 2 Front Door Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the No. 2 front door stripe and vehicle body.
Pull back on one of the ends of the No. 2 front door stripe to remove it.
When pulling on the No. 2 front door stripe, pull it parallel to the vehicle body.