Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › SFI SYSTEM › from 2020.08
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0292315 SFI SYSTEM L

3ZR-FAE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


WHEN USING GTS


CAUTION:
·

Strictly obey all traffic rules and regulations.

·

Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

·
A371909

Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.

·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.




INITIALIZATION


NOTICE:
·

Perform Registration (VIN registration or frame number registration) when replacing the ECM.

Click hereEngine / Hybrid System>3ZR-FAE (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION

·

Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).

·

Make sure to perform Reset Memory (CVT initialization), deceleration sensor zero point calibration and CVT oil pressure calibration when replacing the ECM or the oil pressure sensor.

Click hereDrivetrain>K114 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





IGNITION SWITCH EXPRESSIONS


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.


Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)


PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY


When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.