The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the park/neutral position switch removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
28800
4.REMOVE BATTERY
53141F
5.REMOVE RADIATOR COVER
17751
6.REMOVE NO. 1 AIR CLEANER INLET
17705
7.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17701
8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
9.REMOVE ECM
74404A
10.REMOVE BATTERY CLAMP SUB-ASSEMBLY
33820B
11.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
84540
12.REMOVE PARK/NEUTRAL POSITION SWITCH
Disconnect the park/neutral position switch connector.
Remove the nut, washer and control shaft lever from the continuously variable transaxle assembly.
Using a screwdriver, bend back the tabs of the lock plate.
Remove the lock nut and lock plate from the park/neutral position switch.
Remove the 2 bolts and park/neutral position switch from the continuously variable transaxle assembly.