The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the clutch pedal support assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
31410
2.DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY
Remove the clip from the clevis pin.
Remove the clevis pin and disconnect the clutch master cylinder assembly from the clutch pedal sub-assembly.
3.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY
Disconnect the 2 connectors.
Disengage the 3 clamps from the clutch pedal support assembly.
Remove the 4 nuts and clutch pedal support assembly from the body and clutch master cylinder assembly.
88280A
4.REMOVE CLUTCH SWITCH ASSEMBLY
89280
5.REMOVE CLUTCH PEDAL STROKE SENSOR ASSEMBLY
31301A
6.REMOVE CLUTCH PEDAL SPRING
Move the pedal to the full stroke position and remove the clutch pedal spring.
31301
7.REMOVE CLUTCH PEDAL SUB-ASSEMBLY
Remove the bolt, nut and clutch pedal sub-assembly from the clutch pedal support sub-assembly.
31353
8.REMOVE CLUTCH PEDAL SPRING HOLDER
Remove the clutch pedal spring holder from the clutch pedal support sub-assembly.
9.REMOVE CLUTCH PEDAL TURNOVER BUSH
Remove the clutch pedal turnover bush from the clutch pedal sub-assembly.
31324A
10.REMOVE CLUTCH PEDAL SHAFT COLLAR
Remove the 2 clutch pedal bushes and clutch pedal shaft collar from the clutch pedal sub-assembly.
31453B
11.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH
Using SST and a hammer, tap out the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.
31321
12.REMOVE CLUTCH PEDAL PAD
Remove the clutch pedal pad from the clutch pedal sub-assembly.