28800
1.INSTALL BATTERY
Perform "clear the integrated current value", "switch battery type" after replacing the battery.
Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE
Install the battery to the vehicle.
Install the No. 2 battery clamp with the bolt.
Install the battery insulator to the battery.
Connect the cable to the positive (+) battery terminal and engage the clamp.
Tighten the nut.
Engage the 2 claws and install the fusible link cover.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Connect the cable to the negative (-) battery terminal and tighten the nut.
3. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic leaning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART