Home › Engine / Hybrid System › 3ZR-FAE (STARTING) › STARTER › from 2020.08
RM32H0E _51 Engine / Hybrid System _060200 3ZR-FAE STARTING _0295165 STARTER A

3ZR-FAE STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Simple intelligent parking assist system*1 Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A392534

Disconnect the starter assembly connector.


b.
A392535

Open the terminal cap.


c.

Remove the nut to disconnect the wire harness from terminal 30.


d.
A392536

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.