Home › Vehicle Interior › SEAT › POWER SEAT TRACK RAIL ASSEMBLY › from 2019.09
RM32H0E _58 Vehicle Interior _059623 SEAT _0485108 POWER SEAT TRACK RAIL ASSEMBLY A

SEAT  POWER SEAT TRACK RAIL ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Power seat is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 72108 1.INSTALL UPPER SEAT TRACK RAIL SUB-ASSEMBLY LH

CAUTION:

Make sure to read the warnings printed on the box of the upper seat track rail sub-assembly LH before performing operations.


NOTICE:
·
B583206C01
2.344,2.667 2.563,2.854 0.219,0.188 10 false *a
*a 80 mm (3.15 in.)


In order to reduce the risk of damage to the part and to ensure ease of operations, secure a space of 80 mm (3.15 in.) or more as shown in the illustration.

·

Secure enough space to ensure that the upper seat track rail sub-assembly LH does not contact any other objects during installation.



a.
B583213

Install a new upper seat track rail sub-assembly LH with the 8 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


b.

Engage the clamp.


c.
B583214C01
0,0 0,0 false
V113147

Install in this direction


Engage the clamp and claw to install the front seat lower No. 1 cushion shield LH as shown in the illustration.


d.
B583215C01
0,0 0,0 false
V113147

Install in this direction


Engage the guide and claw to install the front seat lower cushion shield LH as shown in the illustration.


e.
B583216C01
2.115,0.958 2.729,0.792 true 2.552,2 3.167,1.917 true 2.75,0.688 2.948,0.885 0.198,0.198 10 false *a 3.188,1.833 3.375,2.021 0.188,0.188 10 false *b
*a Clamp
*b Guide
V113147

Install in this direction


Engage the guide and claw to install the front seat lower cushion shield RH as shown in the illustration.


f.

Engage the clamp.


g.
B583217C01
0,0 0,0 false
V113147

Install in this direction


Engage the guide and 2 claws as shown in the illustration.


h.
B583208

Install the 2 screws to install the front seat cushion wire harness holder LH.


i.
B583207

Engage the claw and 2 clamps.


j.

Connect the slide motor connector.


Hide 71812D 2.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 71868A 3.INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD LH