2006-2011 Camry Aurion · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jun 2006

HINT:
When installing the outside moulding, heat the vehicle body and outside moulding using a heat light.

Heating temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and outside moulding excessively.


1. INSTALL FRONT DOOR OUTSIDE MOULDING
  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Clean the front door outside moulding. (If reusing the front door outside moulding)

    B149521E01

    1. Using a heat light, carefully heat the front door outside moulding.

    2. Remove the double-sided tape from the front door outside moulding.

    3. Wipe off any tape adhesive residue with cleaner.

    4. Apply new double-sided tape to the front door outside moulding.

  1. Install the front door outside moulding.

    1. Using a heat light, carefully heat the vehicle body and front door outside moulding.

    2. Remove the release paper from the face of the front door outside moulding.

      HINT:
      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. Install the front door outside moulding.


2. INSTALL REAR DOOR OUTSIDE MOULDING
  1. Clean the vehicle body surface.

    1. Using a heat light, heat the vehicle body surface.

    2. Remove the double-sided tape from the vehicle body.

    3. Wipe off any tape adhesive residue with cleaner.

  1. Clean the rear door outside moulding. (If reusing the rear door outside moulding)

    B149522E01

    1. Using a heat light, carefully heat the rear door outside moulding.

    2. Remove the double-sided tape from the rear door outside moulding.

    3. Wipe off any tape adhesive residue with cleaner.

    4. Apply new double-sided tape to the rear door outside moulding.

  1. Install the rear door outside moulding.

    1. Using a heat light, carefully heat the vehicle body and rear door outside moulding.

    2. Remove the release paper from the face of the rear door outside moulding.

      HINT:
      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. Install the rear door outside moulding.

← REMOVAL (from Jun 2006)PRECAUTION (from Oct 2006) →