2006-2011 Camry Aurion · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2009


1. REMOVE REAR BRAKE PAD
  1. Remove the 2 rear disc brake pads with the anti-squeal shims.


2. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN

  1. C143438E01
    Remove the 2 rear disc brake cylinder slide pins (upper and lower) from the rear disc brake cylinder mounting.


3. REMOVE REAR DISC BRAKE BUSHING DUST BOOT

  1. C143450E01
    Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.


4. REMOVE REAR DISC BRAKE PISTON

  1. C111364E06
    Prepare a wooden plate to hold the brake pistons.

  1. Place the wooden plate between the rear disc brake piston and the rear disc brake cylinder assembly.

  1. C143447
    Use compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.

    CAUTION:
    Do not place your fingers in front of the brake piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.


5. REMOVE CYLINDER BOOT
  1. Remove the cylinder boot from the disc brake cylinder assembly.


6. REMOVE PISTON SEAL

  1. C143448
    Using a screwdriver, remove the piston seal from the rear disc brake cylinder assembly.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
  1. Remove the bleeder plug cap from the rear disc brake bleeder plug.


8. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly.


9. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the parking brake shoe adjusting hole plug.


10. REMOVE REAR DISC

  1. C143446E02
    Put matchmarks on the rear disc and the axle hub.

  1. C131914E02
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press the shoe adjuster firmly until the wheel comes free.

← REMOVAL (from Jun 2009)INSPECTION (from Jun 2009) →