REMOVAL
Removal / installation · Vehicles built from Jun 2006
| 1.
REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER |
 |
- HINT:
- When removing the roof drip side finish moulding center, heat the body and roof drip side finish moulding center using a heat light.
- Heating temperature:
Item
|
Temperature
|
Vehicle Body
|
40 to 60°C (104 to 140°F)
|
Moulding
|
20 to 30°C (68 to 86°F)
|
- NOTICE:
- Do not heat the vehicle body and moulding excessively.
- Put protective tape around the roof drip side finish moulding center.
- Using a moulding remover, disengage the 2 clips and remove the roof drip side finish moulding center.
- NOTICE:
- Do not remove the clips.
- If the clips are damaged or dropped off, replace them with new ones.
| 2.
REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP |
 |
- HINT:
- Perform the following procedure if replacing the roof drip side finish moulding clips.
- Remove the 2 roof drip side finish moulding clips.