2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Front Wiper Motor Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The windshield wiper relay assembly (auto wiper relay) controls the front wiper motor.

WIRING DIAGRAM

E119083E05

INSPECTION PROCEDURE


1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY

  1. E034081E47
    Remove the windshield wiper motor assembly (Click here).

  1. Check the LO operation.

    1. Connect the positive (+) battery lead to terminal A59-1 (+1) of the connector, and the negative (-) battery lead to terminal A59-5 (E), and check that the motor operates at low speed.

  1. Check the HI operation.

    1. Connect the positive (+) battery lead to terminal A59-4 (+2) of the connector, and the negative (-) battery lead to terminal A59-3 (+S), and check that the motor operates at high speed.



NG
REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (WIPER MOTOR - WIPER RELAY, BODY GROUND)

  1. E124959E05
    Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A59-1 (+1) - E26-2 (+1)
    Always
    Below 1 Ω
    A59-1 (+1) - Body ground
    Always
    10 kΩ or higher
    A59-3 (+S) - E26-10 (+SM)
    Always
    Below 1 Ω
    A59-3 (+S) - Body ground
    Always
    10 kΩ or higher
    A59-4 (+2) - E26-3 (+2)
    Always
    Below 1 Ω
    A59-4 (+2) - Body ground
    Always
    10 kΩ or higher
    A59-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← FAIL-SAFE CHART (from Oct 2006)Wiper Motor Power Source Circuit (Oct 2006 – May 2009) →