2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

Cruise Main Indicator Light Circuit

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

  1. The ECM detects a cruise control switch signal and sends it to the combination meter through CAN. Then the CRUISE main indicator light comes on.
  2. The CRUISE main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Check the CRUISE main indicator light by performing the ACTIVE TEST.

    Combination meter: 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Indicat. Lamp Cruise
    CRUISE main indicator light
    Indicator light BLINK / OFF
    -

    OK:
    Indicator light comes on/goes off.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2. READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

  1. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

    ECM (Cruise control): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CRUISE" on
    OFF: "CRUISE" off
    -

    OK:
    When the cruise control main switch is operated, the display changes as shown above.



NG
REPLACE ECM (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Cruise Control Switch Circuit (Jun 2006 – Sep 2006)TC and CG Terminal Circuit (Jun 2006 – Sep 2006) →