2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

GPS Mark is not Displayed

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

INSPECTION PROCEDURE


1. CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely faint radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    The mark appears.



NG
Go to step 2
OK

NORMAL OPERATION

2. CHECK SURROUNDINGS

  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction, and time. For illustrated examples, see below.

    I100196E03

    OK:
    GPS mark is displayed.



NG
Go to step 3
OK

SYSTEM RETURNS TO NORMAL

3. CHECK GPS INFORMATION (NAVIGATION CHECK MODE)
E136194E01
  1. Enter the "Navigation Check" mode (GPS Information) (Click here).

  1. Check how many of the following codes appear in the "STS" column.

    For DENSO Made:
    T, P

    For AISIN AW Made:
    08H, 04H

    OK:
    At least 3 codes appear.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY


← GPS Mark is not Displayed (Jun 2006 – Sep 2006)GPS Mark is not Displayed (from Jun 2009) →