2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

GPS Mark is not Displayed

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

INSPECTION PROCEDURE


1. CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely faint radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    The GPS mark appears.



NG
Go to step 2
OK

NORMAL OPERATION

2. CHECK SURROUNDINGS

  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction, and time. For examples, see the following illustration.

    I100196E07

    OK:
    The GPS mark is displayed.



NG
Go to step 3
OK

SYSTEM RETURNS TO NORMAL

3. CHECK GPS INFORMATION (OPERATION CHECK)
E176551
  1. Enter the "GPS Information" (Check GPS&Vehicle Sensors) (Click here).

  1. Check how many of the following codes appear in the "STS" column.

    HINT:
    T or P appears.

    OK:
    At least 3 codes appear.

    Result:
    Result
    Proceed to
    NG
    A
    OK
    (for 2GR-FE RHD)
    B
    OK
    (except 2GR-FE RHD)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for 2GR-FE RHD) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (except 2GR-FE RHD) (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← GPS Mark is not Displayed (Oct 2006 – May 2009)Voice Guidance does not Function (Jun 2006 – May 2009) →