Voice is not Recognized
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
INSPECTION PROCEDURE
| 1. CHECK NAVIGATION SETTING |
 |
- Enter the "Menu" screen by pressing the "MENU" switch.
Select "Setup".
- Check that "Voice Recognition Guidance" is not OFF.
- OK:
- Voice Recognition Guidance is not OFF.
|
NG |
 |
|
| TURN VOICE RECOGNITION GUIDANCE "ON" |
|
|
| OK |
|
 |
|
| 2. CHECK MAP DISC |
 |
- Check that the map disc is not deformed or cracked.
- OK:
- No deformations or cracks on the map disc.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK MAP DISC |
 |
- Check for dirt on the map disc surface.
- OK:
- No dirt is on the map disc surface.
- NOTICE:
- Do not use a conventional record cleaner or anti-static preservative.
- HINT:
- If the map disc is dirty, clean the map disc by wiping the map disc surface radially with a soft cloth.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 4. CHECK MICROPHONE (NAVIGATION CHECK MODE) |
 |
- Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
- HINT:
- Voice can be recorded up to 5 seconds.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
- OK:
- All check results are normal.
|
NG |
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
| OK |
|
 |
|
| REPLACE NAVIGATION RECEIVER ASSEMBLY |
|