2006-2011 Camry Aurion · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the following procedures to troubleshoot the engine immobiliser system.
  1. The intelligent tester should be used in steps 4 and 6.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:
        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms
    NEXT

    3.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      4.CHECK FOR DTCS
      1. Check for DTCs and note any codes that are output (Click here).

      2. Delete the DTCs.

      3. Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTCs.

        Result:
        Result
        Proceed to
        DTC output does not recur
        A
        SFI system DTC output recurs
        B
        (Click here)
        Engine immobiliser system DTC output recurs
        C
        (Click here)


      B.

      C.
      A

      5.PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. DATA LIST/ACTIVE TEST (Click here)

      2. TERMINALS OF ECU (Click here)

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← SYSTEM DESCRIPTION (from Oct 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009) →