2006-2011 Camry Aurion · Service Manual BODY

DATA LIST / ACTIVE TEST

System information · Vehicles built from Oct 2006


READ DATA LIST

HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. E138501E01
    Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Read the DATA LIST.

    Driver Seat: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Reclin SW Rear
    Reclining switch signal (Rearward) / ON or OFF
    ON: Reclining switch (Rearward) is ON
    OFF: Reclining switch (Rearward) is OFF
    -
    Reclin SW Front
    Reclining switch signal (Forward) / ON or OFF
    ON: Reclining switch (Forward) is ON
    OFF: Reclining switch (Forward) is OFF
    -
    F Vtcl SW Down
    Front vertical switch signal (Downward) / ON or OFF
    ON: Front vertical switch (Downward) is ON
    OFF: Front vertical switch (Downward) is OFF
    -
    F Vtcl SW Up
    Front vertical switch signal (Upward) / ON or OFF
    ON: Front vertical switch (Upward) is ON
    OFF: Front vertical switch (Upward) is OFF
    -
    Lifter SW Down
    Lifter switch (Downward) / ON or OFF
    ON: Lifter switch (Downward) is ON
    OFF: Lifter switch (Downward) is OFF
    -
    Lifter SW Up
    Lifter switch (Upward) / ON or OFF
    ON: Lifter switch (Upward) is ON
    OFF: Lifter switch (Upward) is OFF
    -
    Slide SW Rear
    Sliding switch signal (Rearward) / ON or OFF
    ON: Sliding switch (Rearward) is ON
    OFF: Sliding switch (Rearward) is OFF
    -
    Slide SW Front
    Sliding switch signal (Forward) / ON or OFF
    ON: Sliding switch (Forward) is ON
    OFF: Sliding switch (Forward) is OFF
    -
    SET SW
    SET switch signal / ON or OFF
    ON: SET switch is ON
    OFF: SET switch is OFF
    -
    M1 SW
    M1 switch signal / ON or OFF
    ON: M1 switch is ON
    OFF: M1 switch is OFF
    -
    M2 SW
    M2 switch signal / ON or OFF
    ON: M2 switch is ON
    OFF: M2 switch is OFF
    -
    Seat Mem M1
    Driving position memorized with M1 switch / MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Seat Mem M2
    Driving position memorized with M2 switch / MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    IG SW
    Communication state of engine switch signal / ON or OFF
    ON: Engine switch on (IG) signal is received
    OFF: Engine switch on (IG) signal is not received
    -
    Key SW
    Engine switch status (IG) / ON or OFF
    ON: Engine switch on (IG)
    OFF: Engine switch off
    -
    Key Cord Conf
    Recognition code is registered / ON or OFF
    ON: One or more recognition codes are registered
    OFF: No recognition code is registered
    -
    DCTY SW
    Door courtesy switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P SW
    Shift lever position P signal / ON or OFF
    ON: Shift lever in P position
    OFF: Shift lever in any position other than P
    -
    PKB SW
    Parking brake switch status / ON or OFF
    ON: Parking brake is operated
    OFF: Parking brake is released
    -
    Vehicle Spd
    Vehicle speed data / MIN.: 0 km/h (0 mph), MAX.: 255 km/h (158 mph)
    Actual vehicle speed
    -
    Power Voltage
    Power supply for front power seat switch (position control ECU) / MIN.: 0 V, MAX.: 19.89 V
    Within range from 11 to 14 V
    -
    Slide Pos
    Seat sliding position / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Reclin Pos
    Seatback position / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    F Vtcl Pos
    Seat front vertical position / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Lifter Pos
    Seat lifter position / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Slide Mem Pos 1
    Seat sliding position memorized with M1 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Recln Mem Pos 1
    Seatback position memorized with M1 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    F Vtcl Mem Pos 1
    Seat front vertical position memorized with M1 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Lifter Mem Pos 1
    Seat lifter position memorized with M1 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Slide Mem Pos 2
    Seat sliding position memorized with M2 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Recln Mem Pos 2
    Seatback position memorized with M2 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    F Vtcl Mem Pos 2
    Seat front vertical position memorized with M2 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -
    Lifter Mem Pos 2
    Seat lifter position memorized with M2 switch / MIN.: -4096, MAX.: 4096
    Within range from -4096 to 4096
    -


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's ACTIVE TEST allows a relay, VSV, actuator, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. E138501E01
    Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Perform the ACTIVE TEST.

    Driver Seat: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Reclining
    Seat reclining operation
    FRONT / REAR
    -
    F Vertical
    Seat front vertical operation
    UP / DOWN
    -
    Lifter
    Seat lifter operation
    UP / DOWN
    -
    Slide
    Seat sliding operation
    FRONT / REAR
    -

← DIAGNOSIS SYSTEM (from Oct 2006)Power Seat Motor Circuit (from Oct 2006) →