2006-2011 Camry Aurion · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A136021
    Disconnect the fuel sender gauge connector.

  1. A136022
    Unlock the fuel sender gauge, and slide it to remove.


2. REMOVE FUEL NO. 1 TANK BAND BRACKET

  1. A136234E01
    Using needle nozzle pliers, remove the E-ring.

  1. A136232
    Disengage the 4 claws of the fuel No. 1 suction support and remove the fuel No. 1 tank band bracket from the fuel suction plate with the fuel filter.

  1. Remove the spring from the fuel suction plate.


3. REMOVE FUEL NO. 1 SUCTION SUPPORT

  1. A136233
    Using a screwdriver with the tip taped, disengage the claw and remove the fuel No. 1 suction support.


4. DISCONNECT FUEL PUMP HARNESS

  1. A136231
    Disconnect the fuel pump harness connector from the fuel suction plate.


5. REMOVE FUEL PUMP

  1. A136239E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws and pull out the fuel pump from the fuel filter assembly.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Do not remove the suction filter.

  1. A136237
    Remove the fuel pump harness connector.

  1. A136238E01
    Remove the O-ring from the fuel pump.


6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

  1. A136235
    Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator from the fuel filter.

  1. A096585E03
    Remove the 2 O-rings from the fuel pressure regulator.

← REMOVAL (from Jun 2009)INSPECTION (from Jun 2006) →