Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
Install the rear airbag sensor with the bolt.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
NOTICE:
If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the rear airbag sensor.
Connect the connector.
2.
INSTALL REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type)
Install the rear side seatback assembly with the bolt.
Torque:
18 N*m{
184 kgf*cm
, 13 ft.*lbf
}
3.
INSTALL ROOF SIDE INNER GARNISH (for Fold Down Seat Type)
Engage the 5 clips and 2 claws, then install the roof side inner garnish LH.
4.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (for Fold Down Seat Type)
Install the rear door opening trim weatherstrip LH as shown in the illustration.
NOTICE:
After installation, check that the corners fit correctly.
5.
INSTALL REAR DOOR SCUFF PLATE (for Fold Down Seat Type)
Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.