HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 from Oct 2006
- HINT:
- Use the following procedures to troubleshoot the sliding roof system.
- *: Use the intelligent tester.
- Use the following procedures to troubleshoot the sliding roof system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
- If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Using the intelligent tester, check if the CAN communication system is functioning normally.
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
- Data List / Active Test (Click here)
- Terminals of ECU (Click here)
- On-vehicle Inspection (Click here)
| |||||
| 6.ADJUST, REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||