2006-2011 Camry Aurion · Service Manual RESTRAINTS

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).


INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as mentioned below, replace the rear airbag sensor with a new one:

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    Be sure to follow the correct removal and installation procedure.


INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
  1. Replace the rear airbag sensor.

    CAUTION:
    Be sure to follow the correct removal and installation procedure.

    HINT:
    The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag assembly has deployed.

← ON-VEHICLE INSPECTION (Oct 2006 – May 2009)REMOVAL (Jun 2006 – Sep 2006) →