2006-2011 Camry Aurion · Service Manual TRANSMISSION

MANUAL SHIFTING TEST

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


PERFORM MANUAL SHIFTING TEST

HINT:
  1. With this test, it can be determined whether trouble occurs in the electrical circuit or is a mechanical problem in the transaxle.
  2. If any abnormalities are found in the following test, the problem is in the transaxle itself.

  1. C145256
    Disconnect the TCM connector.

  2. Drive the vehicle with the TCM disconnected.
    Shifting the shift lever to the D position to check whether the shifting condition changes as shown in the table below.

    Shift Position
    Shifting Condition
    D
    No Shift (No Change)

    HINT:
    When driving the vehicle with the TCM disconnected, the gear position will be as follows:
    1. When the shift lever is in the D position, the transmission will stay in 3rd gear.
    2. When the shift lever is in the R or P position, the transmission will also be in the R or P position respectively.

  3. Connect the connector of the TCM.

  4. Clear the DTC (Click here).

← HYDRAULIC TEST (from Oct 2006)MANUAL SHIFTING TEST (from Jun 2009) →