MANUAL SHIFTING TEST
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| PERFORM MANUAL SHIFTING TEST |
- HINT:
- With this test, it can be determined whether trouble occurs in the electrical circuit or is a mechanical problem in the transaxle.
- If any abnormalities are found in the following test, the problem is in the transaxle itself.
- With this test, it can be determined whether trouble occurs in the electrical circuit or is a mechanical problem in the transaxle.
Disconnect the TCM connector.

Drive the vehicle with the TCM disconnected.
Shifting the shift lever to the D position to check whether the shifting condition changes as shown in the table below.Shift Position
Shifting Condition
D
No Shift (No Change)
- HINT:
- When driving the vehicle with the TCM disconnected, the gear position will be as follows:
- When the shift lever is in the D position, the transmission will stay in 3rd gear.
- When the shift lever is in the R or P position, the transmission will also be in the R or P position respectively.
- When the shift lever is in the D position, the transmission will stay in 3rd gear.
Connect the connector of the TCM.
Clear the DTC (Click here).