P0604 Internal Control Module Random Access Memory (RAM) Error
Diagnostic trouble codes · Vehicles built from Jun 2009
Also covers:
- P0606 ECM / PCM Processor
- P0607 Control Module Performance
- P060A Internal Control Module Monitoring Processor Performance
- P060D Internal Control Module Accelerator Pedal Position Performance
- P060E Internal Control Module Throttle Position Performance
- P0657 Actuator Supply Voltage Circuit / Open
- P1607 Cruise Control Input Processor
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The ECM continuously monitors its internal memory status, internal circuits, and output signals sent to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the appropriate DTC and illuminate the MIL.The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the 2 CPUs are different and deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0604 P0606 P0607 P060A P060D P060E P0657 P1607 |
ECM internal error (1 trip detection logic) |
ECM |
INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air-fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction (Click here).
| 1. CHECK OTHER DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Clear the DTC (Click here).
Turn the ignition switch off and turn the tester off.
Disconnect the intelligent tester.
Disconnect the battery negative terminal and wait for 1 minute.
Connect the battery negative terminal.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Turn the ignition switch on (IG).
Enter the following menus: Powertrain / Engine / DTC.
Read the DTCs.
- Result:
Display (DTC output)
Proceed to
P0604, P0606, P0607, P060A, P060D, P060E, P0657 and/or P1607 are output
A
P0604, P0606, P0607, P060A, P060D, P060E, P0657, P1607 and other DTCs are output
B
No output DTC
C
|
|
||||
|
|
||||
| A | ||
| ||
