2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

PRECAUTION

Precautions · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1.STEERING SYSTEM HANDLING PRECAUTIONS
  1. Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.


2. SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
  1. This vehicle is equipped with an SRS (Supplemental Restraint System) which includes parts such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precautionary notice for the Supplemental Restraint System (Click here).


3.BUS WIRE REPAIR

  1. F045104
    After repairing a bus wire with solder, wrap the repaired part with electrical tape.

    NOTICE:
    1. The CANL bus wire and CANH bus wire must be installed together at all times.
    2. When installing, make sure that they are twisted.
    3. CAN bus wires are likely to be influenced by electrical noise if the bus wires are not twisted.
    4. The difference in length between the CANL bus wire and CANH bus wire should be 100 mm (3.937 in.) or less.
    5. Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connector.

  2. F045105E01
    Do not use bypass wiring between the connectors.

    NOTICE:
    The ability of the twisted bus wires to resist interference will be lost if bypass wiring is used.


4.CONNECTOR HANDLING

  1. F045106E01
    When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.

  2. F045107E13
    Use service wires to check the connector if it is impossible to check resistance from the rear of the connector.


5.PRECAUTIONS FOR INSPECTING OR REPLACING CAN J/C
  1. If the CAN J/C is removed from the vehicle for inspection or replacement, make sure to install the CAN J/C and all wire harnesses to their original locations with tape and the clamps.

← Open in One Side of CAN Branch Line (from Jun 2009)PRECAUTION (from Jun 2009) →