2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "Engine" and "ECT" are not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "ECM Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the ECM
  2. ECM main bus wire or connector
  3. ECM

WIRING DIAGRAM

C145017E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN BUS WIRE (ECM MAIN BUS WIRE)

  1. G100098E22
    Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-41 (CANH) - A24-49 (CANL)
    Ignition switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (ECM MAIN BUS WIRE)
OK


2. CHECK ECM POWER SOURCE CIRCUIT
  1. Check the ECM power source circuit (Click here).



NG
REPAIR OR REPLACE ECM POWER SOURCE CIRCUIT
OK

REPLACE ECM


← Air Conditioning Amplifier Communication Stop Mode (Jun 2006 – Sep 2006)Main Body ECU Communication Stop Mode (Jun 2006 – Sep 2006) →