2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Air Conditioning Amplifier Communication Stop Mode

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Air Conditioning Amplifier Communication Stop Mode
  1. "Air Conditioner" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Air Conditioning Amplifier Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the air conditioning amplifier
  2. Air conditioning amplifier branch wire or connector
  3. Air conditioning amplifier

WIRING DIAGRAM

C133239E04

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN main wires and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN BUS WIRE (AIR CONDITIONING AMPLIFIER BRANCH WIRE)

  1. E124470E21
    Turn the ignition switch off.

  1. Disconnect the air conditioning amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-11 (CANH) - E38-12 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO AIR CONDITIONING AMPLIFIER (CAN-H, CAN-L)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. E124470E22
    Disconnect the air conditioning amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E38-14 (GND) - Body Ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E38-1 (IG+) - Body Ground
    Ignition switch on
    10 to 14 V
    E38-21 (B) - Body Ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER


← Skid Control ECU Communication Stop Mode (Jun 2006 – Sep 2006)ECM Communication Stop Mode (Jun 2006 – Sep 2006) →