2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
  1. "ENGINE" and "ECT" are not displayed on the "Communication Bus Check" screen of the intelligent tester
  1. Applies to "ECM Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the ECM
  1. ECM

HINT:
"ENGINE" and "ECT" refer to the circuit that includes the ECM.


WIRING DIAGRAM

C225751E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS MAIN WIRE (ECM MAIN WIRE)
  1. Turn the engine switch off.

  1. C136709E15
    Disconnect ECM connectors A55.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    A55-41 (CANH) - A55-49 (CANL)
    Engine switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS MAIN WIRE OR CONNECTOR (ECM MAIN WIRE)
OK


2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT)

  1. C136709E16
    Disconnect ECM connector C55.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    C55-81 (E1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    A55-1 (+B2) - Body ground
    Engine switch off
    10 to 14 V
    A55-2 (+B) - Body ground
    Engine switch off
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM


← Yaw Rate Sensor Communication Stop Mode (from Oct 2006)Main Body ECU Communication Stop Mode (from Oct 2006) →