2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Main Body ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Main Body ECU Communication Stop Mode
  1. "Main Body" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Main Body ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the main body ECU
  2. Main body ECU branch wire or connector
  3. Main body ECU

HINT:
"Main Body" refers to the circuit that includes the main body ECU.


WIRING DIAGRAM

C142745E02

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (MAIN BODY ECU BRANCH WIRE)

  1. B137983E02
    Turn the engine switch off.

  1. Disconnect the main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E8-5 (CANH) - E8-6 (CANL)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS BRANCH WIRE OR CONNECTOR (MAIN BODY ECU BRANCH WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C133238E02
    Disconnect the IF J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IF-10 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    IF-11 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V

  1. Reconnect the main body ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← ECM Communication Stop Mode (from Oct 2006)Combination Meter ECU Communication Stop Mode (from Oct 2006) →