Driver Side Door UNLOCK Detection Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
The driver's door unlock detection switch is built into the driver's door lock assembly. The switch turns on when the driver's door is unlocked and turns off when the door is locked.The main body ECU is connected to the driver's door lock assembly via terminal LSWD and driver's door lock/unlock state signals are input to the main body ECU.
The main body ECU applies voltage to the door unlock detection switch via terminal LSWD. When the door unlock detection switch is on (there is continuity between the switch terminals), an unlock state signal is input to the main body ECU. When the switch is off (there is no continuity between the switch terminals), a lock state signal is input.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING DATA LIST (DOOR UNLOCK DETECTION SWITCH) |
Check the DATA LIST to ensure proper function of the door unlock detection switch.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D-Door Lock Pos SW
Driver side door unlock detection switch signal/ON or OFF
ON: Driver side door is unlocked
OFF: Driver side door is locked
-
- OK:
- The display is as specified in the normal condition column.
|
|
||||
| OK | ||
| ||
| 2. INSPECT FRONT DOOR LOCK ASSEMBLY (DOOR UNLOCK DETECTION SWITCH) |
Inspect LHD models.

Remove the front door lock assembly LH.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Measurement Condition
Door Lock Condition
Specified Condition
7 - 8
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
10 kΩ or higher
7 - 8
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Below 1 Ω
Inspect RHD models.

Remove the front door lock assembly RH.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Measurement Condition
Door Lock Condition
Specified Condition
7 - 8
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 1
Lock
10 kΩ or higher
7 - 8
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 4
Unlock
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK WIRE HARNESS (FRONT DOOR LOCK ASSEMBLY - MAIN BODY ECU) |
Disconnect the front door lock assembly connector.

Disconnect the main body ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
(Symbols)
Condition
Specified Condition
(*1) I7-8 (LSSR) - E7-9 (LSWD)
Always
Below 1 Ω
(*1) I7-8 (LSSR) - Body ground
Always
10 kΩ or higher
(*1) I7-7 (E) - Body ground
Always
Below 1 Ω
(*2) H8-7 (LSSR) - E7-9 (LSWD)
Always
Below 1 Ω
(*2) H8-7 (LSSR) - Body ground
Always
10 kΩ or higher
(*2) H8-8 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
